Repair Instructions
7.17 Vibration damping system
Disassembly
1
Release the brake by moving the hand guard
backwards. Remove the cylinder cover, the clutch
cover, the chain and the bar.
2
Loosen the screws as outlined in Figure 53.
Dismantle the hand guard.
3
Press down the throttle valve shaft (1) and remove
the throttle pressure rod (2) out of its fastening.
See figure 54.
Remove the throttle pressure rod.
4
Remove the handle system.
Cleaning and inspection
•
Clean and check all parts thoroughly. Parts
must be replaced if cracked or showing signs
of other defects. Always use original spare
parts.
Assembly
1
Assemble the handle system and fasten the
screws as outlined in figure 53. Assemble the hand
guard.
2
Fit the throttle pressure rod, cylinder cover, chain
and bar as well as the clutch cover.
46 –
English
Fig 53
Fig 54
Fig 55
1
2