Thermostat And Heating Element - Husqvarna 555 Workshop Manual

7.20.2 To install the guide bar bolts
1. Attach a steel wire to the thread of a guide bar bolt.
2. Put the steel wire through the oil tank and through
the hole for the guide bar bolt.
3. Pull the steel wire to pull out the guide bar bolt.
4. Make sure that the square head of the guide bar bolt
is correctly attached in the oil tank.
5. Put 2 spacers on each guide bar bolt.
6. Attach a nut to each guide bar bolt and tighten the
nuts until the guide bar bolts are tightly attached to
the crankcase.
Note: Fill the tank with chain oil before you operate the
product.
1540 - 001 -

7.21 Thermostat and heating element

7.21.1 To remove and install the thermostat and
heating element
The models 560 XP and 560 XPG has a thermostat and
heating element.
1. Drain the fuel from the fuel tank.
2. Remove the cylinder cover.
3. Remove the spark plug cap and the spark plug.
4. Remove the air filter.
5. Remove the air filter holder. Refer to
install the carburetor on page 36 .
6. Remove the 2 screws and the cover for the heated
handle.
To remove and
Repair instructions - 57