Vibration Damping System; Generator - Husqvarna 545 Mark II Workshop Manual

8.16 Vibration damping system

8.16.1 To disassemble the vibration damping
system
1. Use a Torx to remove the vibration damping unit
from the cylinder.
2. Remove the chain catcher to get access to the
vibration damping system. Use a Torx to remove the
vibration damping unit.
3. Remove the screw to get access to the vibration
damping system. Use a Torx to remove the vibration
damping unit.
8.16.2 To assemble the vibration damping system
1. Assemble the vibration damping system in the
opposite sequence to how it was disassembled.
54 - Repair instructions

8.17 Generator

8.17.1 To disassemble the generator
1. Remove the tank unit. Refer to
tank unit on 545G Mark II and 550 XP
page 49 .
2. Remove the starter unit. Refer to
the starter on page 29 .
3. Remove the flywheel. Refer to
flywheel on page 35 .
4. Remove the screws. Remove the generator and the
wires.
8.17.2 To assemble the generator
1. Pull the cables through the hole in the crankcase.
2. Attach the generator to the crankcase. Tighten the
screws to the correct torque. Refer to
on page 9 .
3. Attach the flywheel.
4. Attach the starter unit.
To disassemble the
®
G Mark II on
To disassemble
To disassemble the
Servicing data
722 - 003 - 26.03.2019