Input Configuration - Extron electronics RGB-DVI 300 User Manual

Input Configuration

The Input Configuration submenu is used to adjust Input Type, Total Pixels, Phase,
Horizontal and Vertical Start (video), and Horizontal and Vertical Active areas.
In addition, with the RGB-HDMI 300 A model only, this submenu is used to adjust the
Audio Gain & Attenuation and also the Audio Delay.
Figure 16.
NOTE: On the on-screen menu display, default values for the current input rates,
total pixels, H active, and V active are accompanied by an asterisk (*).
With the Start or Active options, use the
{
knob to adjust the vertical values. Total Pixels and Phase are adjusted by the
knobs, respectively.
Option
Input
Total Pixels
Phase
Horizontal Start
Vertical Start
Active Pixels
Active Lines
Only the RGB-HDMI 300 A model accepts an audio input and the Audio Gain &
Attenuation and the Audio Delay options are available only with that model.
Select the Audio Gain & Attenuation control and use the
attenuate the signal from +10 to -18 dB.
Select Audio Delay (0 to 255 ms) to eliminate "Lip-sync" effects by compensating for
delays to the video signal introduced by other signal processors and display devices in the
system.
NOTE: The RGB-HDMI 300 A automatically delays audio by approximately 15 ms to
compensate for internal video processing.
Input Configuration Menu
Minimum
RGB (default), YUV, or Auto
Default value (depends on input resolution) ±512
0
0
0
Default value (depends on input resolution) ±512
Default value (depends on input resolution) ±256
RGB-DVI 300 and RGB-HDMI 300 (A) • Configuration
[
knob to adjust the horizontal values and the
Maximum
31
255
255
[
knob to boost (Gain) or
[ {
and
19