Input Configuration - Extron electronics RGB-DVI 300 User Manual

Input Configuration

The
Input Configuration
Horizontal
In addition, with the RGB-HDMI 300 A model only, this submenu is used to adjust the
Gain & Attenuation
Figure 19.
NOTE: On the on-screen menu display, default values for the current input rates, total pixels,
H active, and V active are accompanied by an asterisk (*).
With the
Start
knob to adjust the vertical values. Use the
adjust
Phase
Option
Input
Total Pixels
Phase
Horizontal Start
Vertical Start
Active Pixels
Active Lines
Table 5. Minimum and Maximum Values for Input Configuration Options.
Only the RGB-HDMI 300 A model accepts an audio input and the
and the Audio Delay
Select the
Audio Gain & Attenuation
attenuate the signal from
Select Audio Delay
the video signal introduced by other signal processors and display devices in the system.
NOTE: The RGB-HDMI 300 A automatically delays audio by approximately 15 ms to
compensate for internal video processing.
submenu is used to adjust
and Vertical Start (video), and
and also the Audio Delay
Input Configuration Menu
or options, use the
Active
.
Minimum
RGB (default), YUV, or Auto
Default value (depends on input resolution) ±512
0 31
0 255
0 255
Default value (depends on input resolution) ±512
Default value (depends on input resolution) ±512
options are available only with that model.
control and use the
to dB.
+10 -18
( 0 to 255 ms) to eliminate "lip-sync" effects by compensating for delays to
RGB DVI 300 and RGB HDMI 300 (A) • Configuration
,
Input Type Total Pixels
Horizontal and Vertical Active
.
[ knob to adjust the horizontal values and the {
[ knob to adjust Total Pixels
Maximum
Audio Gain & Attenuation
[ knob to boost (Gain) or
, ,
Phase
areas.
Audio
and the { knob to
20