Output Configuration - Extron electronics RGB-DVI 300 User Manual

Output Configuration

The Output Configuration is used to select a scaler output rate from the various available
resolution and refresh rates. The RGB-DVI 300, RGB-HDMI 300, and RGB-HDMI 300 A have
a large range of combinations of resolution and refresh rate (see Table 1).
Select Output Configuration from the main menu. Use the
Resolution. Then use the
Enter button, or they will be applied automatically after 5 seconds.
Figure 17.
In addition to the resolutions and refresh rates available in the menu, two other options are
available:
• Auto — The unit receives EDID information from the display device and adjusts the
output signal to match the requirements of the display.
•
Lock — The unit matches the resolution and refresh rate of the output signal with those
of the input signal. This produces a 1:1 non scaled, analog to digital conversion.
Color Space — The two available options are RGB (default) and YUV. Use the
toggle between the values and then apply the setting by pressing the Enter button.
HDMI Data (RGB-DVI 300 units shipped after Q3 2010 and RGB-HDMI 300 A only) —
The HDMI signal contains additional embedded information (HDMI data) that may cause
some DVI-only displays to produce an erratic or improper video output. This menu option
allows the HDMI data to be stripped from the signal to make it compatible with DVI-only
displays. The options are:
• Auto (Default) — In this mode the RGB-DVI 300 and RGB-HDMI 300 A read the EDID
from the display and determines if it is capable of receiving ancillary data. If a PC or DVI
only display is detected, the HDMI Data will automatically turn off. If an HDMI capable
sink is detected, the RGB-DVI 300 and RGB-HDMI 300 A will automatically enable the
HDMI Data.
• On — This option enables the HDMI Data regardless of the detected display.
• Off — This option disables the HDMI Data regardless of the detected display.
{
knob to select a Refresh Rate. Apply the settings by pressing the
Output Configuration Menu
RGB-DVI 300 and RGB-HDMI 300 (A) • Configuration
[
knob to select a
{
knob to
20