Running the SPPCP
The computer can be connected to the video scaler using a 9-pin D female connector from
the PC to either the RS-232 captive screw connectors on the rear panel or the Config port
on the front panel of the video scaler.
1.
To start the program, click on the desktop icon (shown at right) or click on
the Windows Start button and select All Programs > Extron Electronics >
Signal Processing"> Signal Processing Products Control Program.
First, the "Select Connection Type" dialog box opens:
Figure 21.
2.
Select the RS-232 tab and then select the computer port (typically COM1 or COM3) and
the baud rate to use (the default rate is 9600).
3.
Click on Connect and the program opens to the main screen. By default the control tab
is selected:
Figure 22.
For complete instructions on controlling the RGB-DVI 300,
RGB-HDMI 300, or RGB-HDMI 300 A using the SPPCP, refer
to the Help File, which can be selected from the Help drop-
down menu or by pressing the F1 key.
Select Connection Type Dialog Box
SPPCP Main Screen
RGB-DVI 300 and RGB-HDMI 300 (A) • Software and Firmware
24