User Presets - Extron electronics RGB-DVI 300 User Manual

User Presets

User Presets are a user-defined set of picture control settings for up to three commonly
used aspect ratio settings. When
described elsewhere in this section, the current values for Contrast, Brightness, Detail,
Horizontal and Vertical Centering, and Horizontal and Vertical Size can be saved. User
Presets can be saved on one input resolution and recalled for a different input
resolution.
To save user presets, navigate to the User Presets > Save submenu. Use the
select user preset 1, 2, or 3 and press Enter to save, and press Menu to exit.
Figure 15.
When a preset has been saved, it can be recalled or cleared using the Recall or Clear
options. Select a user preset (1, 2, or 3) to be recalled or cleared and press Enter.
NOTE: The brackets <> around the current selection are only visible when that function
(recall, save, or clear) has been activated. If you try to recall a user preset
that has not yet been saved, an "Invalid Preset" message will appear on the
on-screen display.
User Presets
Contrast
Brightness
Detail
Table 3.
An additional 16 presets (input presets) are available through SIS commands only. Input
presets save picture control settings (the same values saved by user presets) and input
configuration values (input type, total pixels, horizontal and vertical starts, horizontal and
vertical active areas and phase). The exact settings of a source are saved and can be recalled
each time that source is applied. Input presets are only valid for the source/resolution
that was active when the preset was saved.
Picture Controls
User Presets Menu
H position
V position
H size
V size
Zoom
Comparison of User Presets and Input Presets
RGB-DVI 300 and RGB-HDMI 300 (A) • Configuration
and Input Configuration
Input Presets
Input type H start
Total pixel V start
Contrast H active
Brightness V active
Detail Phase
are set, as
{
knob to
H position
V position
H size
V size
Zoom
18