Planet GSD-1020S User Manual page 43

 Manual Time
 Time Zone
 Daylight Saving Time
 Daylight Saving Time
Offset
 Recurring From
 Recurring To
 Non-recurring From
 Non-recurring To
SNTP messages between the clients and the server when they are not
on the same subnet domain.
Disabled: Disable SNTP mode operation.
To set time manually.
 Year - Select the starting Year.
 Month - Select the starting month.
 Day - Select the starting day.
 Hours - Select the starting hour.
 Minutes - Select the starting minute.
 Seconds - Select the starting seconds.
Allow select the time zone according to current location of switch.
This is used to set the clock forward or backward according to the configurations
set below for a defined Daylight Saving Time duration. Select 'Disable' to disable
the Daylight Saving Time configuration. Select 'Recurring' and configure the
Daylight Saving Time duration to repeat the configuration every year. Select
'Non-Recurring' and configure the Daylight Saving Time duration for single time
configuration. (Default : Disabled ).
Enter the number of minutes to add during Daylight Saving Time. ( Range: 1 to
1440 )
 Week - Select the starting week number.
 Day - Select the starting day.
 Month - Select the starting month.
 Hours - Select the starting hour.

Minutes - Select the starting minute.
 Week - Select the starting week number.
 Day - Select the starting day.
 Month - Select the starting month.
 Hours - Select the starting hour.

Minutes - Select the starting minute.
 Week - Select the starting week number.
 Day - Select the starting day.
 Month - Select the starting month.
 Hours - Select the starting hour.

Minutes - Select the starting minute.
 Week - Select the starting week number.
 Day - Select the starting day.
 Month - Select the starting month.
 Hours - Select the starting hour.

Minutes - Select the starting minute.
43
User's Manual of GSD-1020S