3Ware 9650SE-2LPB-10 User Manual page 82

Chapter 6. 3DM 2 (3ware Disk Manager) Introduction
72
To specify initial setup for 3DM 2
During installation, you will be prompted with a series of questions that
determine initial 3DM settings. You can change these later, from within 3DM.
1 3DM2 supports two modes of operation.
-------------------------------------
0 - 3DM2 with remote/local GUI via WEB interface (Default)
1 - 3ware error logger only
Which version of 3DM would you like configured? [0 - 3DM2]
Press Enter to accept the default and install 3DM2 so that you can access
it through a browser.
2 Would you like to have email notification enabled? (Y/N) [Y]
E-mail notification sends an email message when an event occurs.
The default answer to this question is "yes".
If you enable e-mail notification you will be asked to provide additional
information: the name of the mail server, the user name for the person
who will send the E-mail notification (typically the local host name) and
the user name for the person who will receive the e-mail notification
(typically the system administrator).
Please enter the name of your mail server: (default is local
host name)
Please enter the name of the user you want sending e-mail
notification: (default is root)
Please enter the name of the user you want receiving e-mail
notification: (default is 3ware_admin)
To enter multiple e-mail addresses, separate them by a comma or a
semicolon:
3 Please enter the port number you would like to use for web
monitoring (default is 888)
If you do not know what port to use, select the default:
4 Would you like 3DM connection security to limit connections
to localhost only? (default is yes)
If you want to be able to use 3DM for remote administration, change this
to No.
5 Change the directory and then eject the CD-ROM disk when finished:
cd /home
eject cdrom
3ware Serial ATA RAID Controller User Guide