3Ware 9650SE-2LPB-10 User Manual page 218

Chapter 11. 3DM 2 Reference
208
If rebuild scheduling is enabled on the Scheduling page, the unit will not start
actively rebuilding until the scheduled time, and the status will change to say
"Rebuild-Paused." (The Unit Details page indicates whether a unit is actively
rebuilding.) If rebuild scheduling is not enabled, the rebuild process will
begin right away.
For more information about rebuilds, see "To verify a unit through 3BM" on
page 154.
Reconfigures a unit while it is on-line. Migration can be used to
Migrate Unit.
change the RAID level, to expand the capacity by adding additional drives, or
to change the stripe size.
Warning:
Once migration of a unit is started, it cannot be cancelled.
When you select a unit and click
lists the drives in the unit and any additional available drives. In the dialog
box are two drop-down menus, one for choosing the RAID level and one for
choosing stripe size.
You can only migrate a unit to a RAID level that will be larger than the
original unit. For example, you can migrate from a RAID 5 array with 4
drives to a RAID 0 with four drives but you cannot migrate from a RAID 5
with four drives to a RAID 10 with four drives.
After you have specified changes to the unit, the Unit Maintenance screen
reflects your changes and shows the percentage of migration completed.
While the unit is migrating, you can still access the unit as normal but the
performance will be lower. You can adjust the I/O rate with the radio buttons
on the Controller Settings page. (See "Setting Background Task Rate" on
page 160.)
Removes a selected unit and allows you to unplug the drives
Remove Unit.
and move the unit to another controller. The data on the unit remain intact.
Migrate Unit , a dialog box appears which
3ware Serial ATA RAID Controller User Guide