3Ware 9650SE-2LPB-10 User Manual page 192

Chapter 10. Maintaining Your Controller
182
The name of the module you will copy (
Note:
depending on the kernel; however you will always copy it to a file named
3w-9xxx.o for 2.4 kernels, or 3w-9xxx.ko for 2.6 kernels
For Red Hat or Fedora Core Uniprocessor
<version>
cp /3w-9xxx.o /lib/modules/
<kernel>
/drivers/scsi/3w-9xxx.o
For Red Hat SMP
<version>
cp /3w-9xxx.smp /lib/modules/
<kernel>
/drivers/scsi/3w-9xxx.o
For Red Hat Bigmem
<version>
cp /3w-9xxx.big /lib/modules/
<kernel>
/drivers/scsi/3w-9xxx.o
For Red Hat Hugemem
<version>
cp /3w-9xxx.hug /lib/modules/
<kernel>
/drivers/scsi/3w-9xxx.o
5 For 2.4 Kernels, add the following line to
/etc/modules.conf:
alias scsi_hostadapter 3w-9xxx.o
For 2.6 Kernels, add the following line to
/etc/modprobe.conf
alias scsi_hostadapter 3w-9xxx.ko
6 Complete the upgrade by upgrading the initial ramdisk.
Change the directory to the boot directory:
cd /boot
Run mkinitrd by entering the following:
(In the commands below, replace <kernel> with the applicable kernel, for
example 2.4.20-8)
For Red Hat or Fedora Core Uniprocessor
mkinitrd –v –f initrd-
For Red Hat SMP
mkinitrd –v –f initrd-
For Red Hat Bigmem
mkinitrd –v –f initrd-
For Red Hat Hugemem
mkinitrd –v –f initrd-
7 If you are using lilo, run lilo to update to the boot loader.
You should see a printout of kernels that are able to boot on this system
after running lilo.
.
<kernel> <kernel>
.img
<kernel>
smp.img
<kernel>
bigmem.img
<kernel>
hugmem.img
3ware Serial ATA RAID Controller User Guide
) varies,
3w-9xxx.*
<kernel>
smp
<kernel>
bigmem
<kernel>
hugmem