Continue With Windows Nt 4.0 Installation; Install The Driver Using The 3Ware Diskette; Partition Device 0 To Create A Boot Area - 3Ware 3W-6800 User Manual

Continue with Windows NT 4.0 installation

1 When Setup is Inspecting Your Computer Hardware Config-
uration is displayed, press F6 immediately.
2 You will see a Windows NT 4.0 Setup display.
3 Press S to specify that you will be installing an additional mass
storage device. On the display that follows, select Other and
press Enter.

Install the driver using the 3ware diskette

1 You will be asked to insert a manufacturer-supplied hardware
support disk. Insert the 3ware Windows driver installation dis-
kette into the floppy drive and press Enter. DO NOT use the dis-
kette labeled specifically for Windows NT driver installation.
2 Select the 3ware Storage Switch from the display that appears
and press Enter again. Ensure the path to this driver is correct in
Copy manufacturer's files from: at the bottom of the box. To
do this, type A:\winnt
3 After the driver is loaded from the diskette, you will receive the
message "Setup has recognized the following mass storage
devices in your computer:" The list will contain the 3ware Stor-
age Switch. If not, check the hardware and restart this software
installation. Otherwise, press Enter.

Partition device 0 to create a boot area

1 Follow the displayed instructions for Windows NT 4.0 installa-
tion as directed until the following message appears "The list
below shows existing partitions and spaces available for creating
partitions."
2 The partitions list should contain an entry for your Escalade
Storage Switch that resembles the following: 4111 MB Disk 0 at
Id 0 on bus 0 on 3waregsm. If it does not include a 3ware entry,
check your hardware and restart the software installation pro-
cess.
www.3ware.com
Windows NT®4.0 Installation
49