Mercury 1996 Sable Manual page 201

Follow the steps below to set these buttons to
the desired frequencies:
1. Select a band, then select a frequency.
2. Press one of the memory buttons and hold
the button until the sound returns. That
station is now held in memory on that
button.
3. Follow the two steps above for each station
memory preset button you want to set.
Using the Radio Set feature
With Radio set, you can automatically set
strong stations into your memory buttons.
AM, FM1 and FM2 will be set sequentially.
Turn the radio off with the "VOL PUSH ON"
knob. Press and hold the "SCAN" button and
turn the radio on by pressing the "VOL
PUSH ON" knob. Continue holding the
"SCAN" button until "RAD" is shown in the
display.
NOTE: If there are less than six strong stations
in the frequency band, the remaining
unfilled buttons will store the last
strong station detected on the band.
After all stations have been filled, the radio will
begin playing the station stored on memory
button 1.
Adjusting the tone balance and speaker
output of your radio
Increasing or decreasing bass response
Press the right ( a ) side of the "BASS" button
to increase bass (more "lows"); press the left
( b ) side of the "BASS" button to decrease
bass (less "lows").
174