Subaru Legacy Outback 2006 Owner's Manual page 60

1. Sedan: Make the clearance between
the seat cushion and seatback a little wid-
er to locate the two anchor bars for the po-
sition where you want to install the child
restraint system.
Station wagon: Remove the two covers
from the selected side of the rear seat-
back to expose the anchor bars to be used
for installation of the child restraint sys-
tem.
100265
2. While following the instructions sup-
plied by the child restraint system manu-
facturer, connect the connectors of the
child restraint system to the anchor bars.
When the connectors are fastened, make
sure that the adjacent seatbelts are not
caught.
200302
Seat, seatbelt and SRS airbags
1
1) Inserting aid
NOTE
100147
If your child restraint system is provid-
ed with inserting aids, clip them to the
two ISOFIX anchor bars (or put them
between seatback and seat cushion at
the two ISOFIX fastening points) before
connecting the child restraint system.
Position the two connectors just in
front of the two inserting aids. Then in-
sert the two connectors into the insert-
ing aids to connect the connectors to
the anchor bars.
The inserting aids make it easier to fit
the child restraint system with ISOFIX
and avoid damage to the seat.
1-35
100682
– CONTINUED –