Starting The Engine; Manual Transmission Vehicle; Automatic Transmission Vehicle - Subaru Legacy Outback 2006 Owner's Manual

7-6
Starting and operating

Starting the engine

Do not operate the starter motor
continuously for more than ten sec-
onds. If the engine fails to start after
operating the starter for five to ten
seconds, wait for ten seconds or
more before trying again.

Manual transmission vehicle

1. Apply the parking brake.
2. Turn off unnecessary lights and acces-
sories.
3. Press the clutch pedal to the floor and
shift the shift lever into neutral. Hold the
clutch pedal to the floor while starting the
engine.
4. Turn the ignition switch to the "ON" po-
sition and check the operation of the warn-
ing and indicator lights. Refer to the
"Warning and indicator lights" section
(chapter 3).
5. Turn the ignition switch to the "START"
position without depressing the accelera-
tor pedal. Release the key immediately af-
ter the engine has started.
If the engine does not start, try the follow-
ing.
1) Turn the ignition switch to the "LOCK"
position and wait for at least 10 sec-
onds. After checking that the parking
brake is firmly set, turn the ignition
switch to the "START" position while de-
pressing the accelerator pedal slightly
(approximately a quarter of the full
stroke). Release the accelerator pedal
as soon as the engine starts.
2) If this fails to start the engine, turn the
ignition switch back to the "LOCK" posi-
tion and wait for at least 10 seconds.
Then fully depress the accelerator ped-
al and turn the ignition switch to the
"START" position. If the engine starts,
quickly release the accelerator pedal.
3) If this fails to start the engine, turn the
ignition switch again to the "LOCK" po-
sition. After waiting for 10 seconds or
longer, turn the ignition switch to the
"START" position without depressing
the accelerator pedal.
4) If the engine still refuses to start, we
recommend that you contact your near-
est SUBARU dealer for assistance.
6. Confirm that all warning and indicator
lights have gone off after the engine has
started. The fuel injection system auto-
matically lowers the idle speed as the en-
gine warms up.
Automatic transmission vehi-
cle
1. Apply the parking brake.
2. Turn off unnecessary lights and acces-
sories.
3. Shift the selector lever to the "P" or "N"
position (preferably "P" position).
The starter motor will only operate when
the select lever is at the "P" or "N" position.
4. Turn the ignition switch to the "ON" po-
sition and check the operation of the warn-
ing and indicator lights. Refer to the
"Warning and indicator lights" section
(chapter 3).
5. Turn the ignition switch to the "START"
position without depressing the accelera-
tor pedal. Release the key immediately af-
ter the engine has started.
If the engine does not start, try the follow-
ing.
1) Turn the ignition switch to the "LOCK"
position and wait for at least 10 sec-
onds. After checking that the parking
brake is firmly set, turn the ignition
switch to the "START" position while de-
pressing the accelerator pedal slightly
(approximately a quarter of the full
stroke). Release the accelerator pedal
as soon as the engine starts.
2) If this fails to start the engine, turn the
ignition switch back to the "LOCK" posi-