Stopping The Engine - Subaru Legacy Outback 2006 Owner's Manual

tion and wait for at least 10 seconds.
Then fully depress the accelerator ped-
al and turn the ignition switch to the
"START" position. If the engine starts,
quickly release the accelerator pedal.
3) If this fails to start the engine, turn the
ignition switch again to the "LOCK" po-
sition. After waiting for 10 seconds or
longer, turn the ignition switch to the
"START" position without depressing
the accelerator pedal.
4) If the engine still refuses to start, we
recommend that you contact your near-
est SUBARU dealer for assistance.
6. Confirm that all warning and indicator
lights have gone out after the engine has
started. The fuel injection system auto-
matically lowers the idle speed as the en-
gine warms up.
While the engine is warming up, make
sure that the selector lever is at the "P" or
"N" position and that the parking brake is
applied.

Stopping the engine

The ignition switch should be turned off
only when the vehicle is stopped and the
engine is idling.
Do not stop the engine when the ve-
hicle is moving. This will cause loss
of power to the power steering and
the brake booster, making steering
and braking more difficult. It could
also result in accidental activation
of the "LOCK" position on the igni-
tion switch, causing the steering
wheel to lock.
Starting and operating
Manual transmission – 5
speeds
The manual transmission is a fully syn-
chromeshed, 5-forward-speed and 1-re-
verse-speed transmission.
The shift pattern is shown on the shift le-
ver knob. When shifting from 5th gear to
reverse gear, first return the shift lever to
the neutral position then shift into reverse
gear.
To change gears, fully depress the clutch
pedal, move the shift lever, and gradually
let up on the clutch pedal.
If it is difficult to shift into gear, put the
transmission in neutral, release the clutch
pedal momentarily, and then try again.
– CONTINUED –
7-7
700101