9. Troubleshooting Guide
9.1. When the Printing Result Is Not as Expected
Depending on the printing conditions, when printing on a dark-colored fabric that involves the formation of
a background with white ink, an undesired printed image may occur.
For problems with printing results, see the solutions below.
If bleeding occurs
Bleeding as shown below.
Causes:
The following are possible causes.
The height of the image size being less than 100 mm,* and the drying time of the white ink being
•
short.
*If the image size is too small, the proper drying time cannot be ensured after the white ink prints.
•
The drying time is set to 0 sec.
The design of the image uses a lot of dark colors.
•
•
The garment is not pretreated properly.
Large amounts of white ink being ejected. (The intensity is set to 100 instead of the default value of
•
98.)
Color ink flowing when white ink is set to white solid mode (flood or minimum 100 of brightness).
•
When the output profile is set to OFF.
•
Solutions:
Focusing on image quality at the expense of productivity
•
Set the drying time to 20 seconds.
Focusing on productivity by shortening printing time
Select the job in the "Job" archive, and then right-click the selected job.
Click [Settings].
170
RICOH Ri 2000 User Manual