Ricoh Ri 2000 User Manual page 168

9. Troubleshooting Guide
Issue/ Error
Light shirt looks too dull
Cartridge reads 0% but
it was just at a high
percentage (for example
65%) from a previous
operation (before
printing or before
cleaning).
Blot of ink on the shirt
Causes
Nozzle is 100%. Wrong output
profile is selected.
Temporary loss of Comm
caused the cartridge reading
error.
The frame is blotting with ink
The print head rubs against the
media during printing
168
RICOH Ri 2000 User Manual
Solutions
If printing in 600 X 600 Dpi and using a
profile meant for 1200 X 1200 DPI, the
shirt will look dull. Change the profile.
Pull out the cartridge that reads 0%. The
status should change to NC and the
cartridges not loaded message will appear
in the status bar. Put the cartridge back in
and the percentage reading should go
back to normal. If the percentage still
reads 0% after inserting the cartridge
again, turn the printer off and then turn it
back on. The cartridge should read
correctly.
Clean the frame.
Change the [HEIGHT SETTING], and then
perform HEIGHT ADJUST again.
(see page 41, "[HEIGHT SETTING] ").