Kohler KD800 Operation page 51

Menu Access
Some menus are view-only and do not allow
modifications. Some menus require the operator
password to view and/or modify. See Figure 2-58 for
menu access information.
1 - Settings
1.2 Power thresholds
1.5 Timers (not used)
1.6 Auxiliaries
1.8 Parameters
2 - Measurements
2.2 Mechanical
2.3 Generator electrical
2.6 Harmonics
3 - History
3.1 Archiving
4 - Diagnosis
4.1 Variables
4.2 Binary Inputs
4.3 Binary Outputs
4.4 Regulation / protection
4.5 Regulation
5 - Configuration
5.1 Application
5.1.1 General
5.1.2 Alarms
5.1.3 Status Messages
5.1.4 Function Key
5.1.5 Custom view- Visualization
5.1.6 Custom view- Parameters
5.1.7 Main screen custom view
5.1.8 Time slots
5.1.9 Advanced setpoints
5.1.10 Customer messages
5.2 Generator
5.2.1 Starting
5.2.2 Speed
5.2.3 Excitation
5.2.4 Miscellaneous
5.2.5 Timers
TP-7070 8/20
User Operator *
View Modify *
View Modify *
View Modify *
View Modify *
View View
View View
View View
View Modify *
Modify Modify
View View
View View
Modify *
Modify *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
5.3 Regulation
5.3.1 Regulation parameters
5.3.2 Speed regulation PID
5.3.3 Voltage regulation PID
5.3.4 Synchronization PID
5.4 Protection
5.4.1 Low level
5.4.4 Grid
6 - Hardware
6.1 Installation
6.1.1 General
6.1.2 Generator
6.1.3 Regulator
6.1.4 Engine Sensor
6.1.5 Auxiliaries
6.2 Base inputs/outputs
6.2.1 Configurable binary inputs
6.2.2 Resistive inputs
6.2.3 Analog inputs
6.2.4 Analog outputs
6.3 Extension inputs/outputs
6.3.1 CAN inputs/outputs
6.4 Regulation/ protection
6.4.1 General
6.4.2 Regulation modules
6.5 Communication
6.5.1 Ethernet
6.5.2 Serial link
* Operator password (1966) is required to view and/or modify
settings.
Controller must be in Out of Service mode to modify these
settings.
Figure 2-58 Menu Access
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
View *
Modify *
Modify *
Section 2 Operation 51