Kohler KD800 Operation page 44

The Home button on the Remote HMI looks different
than the Home button on the local HMI.
Figure 2-44.
Local HMI
Figure 2-44 Home Buttons
In the case of a Remote HMI in Visualization mode, the
icons in Figure 2-45 show the various displays of key 2.
Figure 2-45 Remote HMI Indication
In the case of a Remote HMI in Operation mode or in Full
access mode, button 2 does not change appearance.
A remote HMI is connected to the Ethernet ring. When
the Home button is pressed, a pop- up window appears;
Figure 2-47 Selecting a Module from a Remote HMI
44 Section 2 Operation
the search for base modules connected to the ring is in
See progress.
At the end of the search, the IP addresses of the
modules connected to the Ethernet ring are shown (see
Figure 2-46). It is also possible to see whether one of the
connected generator sets has a fault (red indicator).
Remote HMI
Figure 2-46 IP Address Display
Select the base module to connect to (in the example,
there is only one generator set). A Connect Generator
#1 button also appears.
Press the Connect Generator #1 button. The window
changes as shown in Figure 2-47.
Press the magnifying glass at the top left-hand of the
screen to start a new search to select another module
connected to the Ethernet ring.
TP-7070 8/20