Ford 1997 Aerostar Manual page 58

NOTE: Rear seat control volume can be set no
higher than current radio setting unless
speakers are turned off. See note under
How to turn the speakers on and off.
Setting the AM or FM frequency band
Push the "BAND" button to change the
frequency band.
Using the "MEMORY" button
Push the "MEMORY" button to access the
station you have set into memory button 1 on
the face of the radio. Successively pushing this
button will access, numerically, all stations set
into the Station Memory Preset buttons (1
through 5).
How to turn the speakers on and off
When the rear seat controls are on, push the
"SPKRS ON-OFF" button to turn all speakers
off. Push again to turn all speakers on.
NOTE: Turning the ignition off then on again
will not turn the speakers back on, if
previously turned off by the "SPKRS
ON-OFF" button on the rear seat
controls.
Using the "SEEK" function
Press the right ( a ) side of the "SEEK" rocker
switch to seek to the next radio station. Press the
left ( b ) side of the "SEEK" rocker switch to
seek to the previous radio station.
NOTE: When using the rear seat controls with
a High-Level Audio System, the
"SEEK" function on the rear seat
controls will also function with
cassettes, seeking the next ("SEEK a ")
or previous (" b SEEK") selection on
the tape.
55