Ford 1997 Aerostar Manual page 274

2. Snap the retaining wire over both sides of
the bulb and connect the electrical connector.
3. Position the headlamp on the vehicle and
install the four attaching screws.
4. Turn the headlamps on and make sure that
they work properly. If the headlamp was
correctly aligned before you changed the
bulb, you should not need to align it again.
Removing the High-Mount Brakelamp
Bulb
Liftgate models
To remove the brakelamp and bulb:
1. Remove the two screws from the surface of
the lens.
2. After removing the screws, remove the lamp
assembly.
3. Disconnect the high-mount brakelamp wiring
connector.
4. Remove the screw retaining the bulb holder
assembly, pull the bulb holder assembly
away from the lamp, and pull the bulb
straight out of the holder.
To replace/install the brakelamp:
1. Push bulb(s) into bulb holder assembly.
2. Place bulb holder assembly on lamp and
install retaining screw. Tighten screw.
3. Connect the high-mount brakelamp wiring
connector.
4. Position the lamp assembly on the vehicle.
5. Install and tighten the two screws.
275