Ford 1997 Aerostar Manual page 105

When reinstalling a rear seat in your
vehicle it must be placed in its original
position. Improper installation of the seat
will prevent correct use of the safety belts
and could increase the risk of injury.
Refer to the warning label on the seat
belt.
2. Fold the seatback forward and latch it in the
down position (bench seat only).
3. Rotate the seat latch handles (located under
the seat near the floor) upward, causing the
latch hooks to disengage from the floor
attachment.
4. Lift seat at rear and rotate about the forward
attachment. When seat latches are clear of
floor attachments, release the latch handles.
5. Pull the seat rearward to disengage it from
the front floor pins.
Be careful that the latches are not damaged
when the seats are stored.
To install the seat assembly:
1. Clear the area of debris around the seat floor
attachments.
2. With the seatback in a folded and latched
position (bench seat only), place the seat
assembly in your vehicle and engage the
front seat hooks onto the forward attachment
pin in the floor wells.
3. Rotate the seat downward and engage the
latch into the rear floor attachment. Lifting
of the latch handles is not required for
installation.
RWARNING
103