Ford 1997 Aerostar Manual page 108

Seat/bed conversion (If Equipped)
Vehicles equipped with the seat/bed can be
either a two passenger or three passenger seat.
To convert the seat/bed to a bed:
1. Pull up the release lever located on right
hand side of the seat, and at the same time
push the seatback rearward.
2. Push the top of the seatback down until it
latches.
The two passenger seat cushion will move
forward when going from the seat to the bed
position.
To convert the bed to a seat:
1. While in front of the seat, pull the release
lever up and at the same time pull the
seatback up. Raise the seatback to the full
upright and locked position.
2. Make sure the safety belts are free and
available for use.
The seat/bed should not be occupied
while the vehicle is moving unless it is in
the upright, fully-latched position.
Using the Lumbar Support and Side
Bolsters
Adjusting the Lumbar Support (If equipped)
To adjust the lumbar pad, turn the knob
clockwise or counterclockwise.
106
RWARNING