New Holland 667TA/EEG Repair Manual page 140

STEP 170
1
2
3
4
5
BS06K399
Complete engine installation as follows.
From the right side:
•
Install the starter (5) to the flywheel housing (4)
and tighten the fastening nuts to 50 to 60 Nm (36.9
to 44.3 lb.-ft.) the specified torque.
•
Install the oil line (3) with a new sealing ring into
the engine block and secure it to the turbo-charger
(1) by the bolts (2) and tighten to 20 to 30 Nm
(14.8 to 22.1 lb.-ft.) the specified torque.
STEP 171
1
2
3
BS06K400
Install the bracket (2) including the fuel filter bracket
(1) to the engine block, tighten the bolts (3) to the
general bolt torque specifications in the repair
manual.
2-122
ENGINE REPAIR MANUAL
CHAPTER 2 - 667TA ENGINE OVERHAUL
Figure 2-273
Figure 2-274
STEP 172
1
2
3
BS06K401
By hand screw on the fuel filter to the bracket (1).
Tighten the fuel filter 3/4 of a turn after the gasket
makes contact with the bracket. Connect the fuel
lines (2,3,4) to the relevant support connections (1)
as shown in the following figure (step 171).
STEP 173
A
1
BS06K388
Press the clamp (1) as shown in (figure B).
After connecting the line reset the clamp (1) to the
initial locking position (A), to prevent deformations.
NOTE: when installation is complete, fill engine with
the proper lubricating oil.
Issued 11-06 Bur
4
5
Figure 2-275
B
1
Figure 2-276
87519804 NA