New Holland 667TA/EEG Repair Manual page 124

STEP 119
1
2
3
BS06K347
Lubricate the sealing ring (2) with engine oil and set it
on the oil filter (3).
Screw oil filter (3) on the oil filter bracket (1) till
gasket makes contact with bracket and then tighten
an additional 3/4 turn (except for 667TA/EEG and
667TAEEC engines)
Apply a new sealing ring on the oil temperature/
pressure sensor (4) and install it on oil filter bracket
(1).
Tighten bolts (5) to 20 Nm (14.8 lb.-ft.) max the
specified torque.
Install a new sealing ring (6) in the engine block seat.
STEP 120
1
2
BS06K348
Position the alternator support (1) so that pins (3) are
set against the engine block.
Tighten the bolts (2) to 40 to 50 Nm (29.5 to 36.9 lb.-
ft.) the specified torque.
2-106
ENGINE REPAIR MANUAL
CHAPTER 2 - 667TA ENGINE OVERHAUL
4
5
6
Figure 2-220
3
Figure 2-221
STEP 121
1
2
BS06K349
Reconnect alternator (1) and tighten the bolts to 40
to 50 Nm (29.5 to 36.9 lb.-ft.) the specified torque.
Reconnect automatic tensioner (4) and tighten bolt
(3) to 40 to 50 Nm (29.5 to 36.9lb.-ft.)specified
torque.
Turn the automatic belt tensioner (4) to install the belt
(2) on pulleys and guide rollers.
STEP 122
1
2
BS06K350
Install the high pressure pump (4) including the feed
pump (5) and tighten the nuts to the specified torque.
Install the support (3) with a new sealing ring, the
timing sensor (2) with a new sealing ring and tighten
the fastening nut (1), to the general bolt torque
specifications in the repair manual.
Issued 11-06 Bur
3
4
Figure 2-222
3
4
5
Figure 2-223
87519804 NA