New Holland 667TA/EEG Repair Manual page 136

STEP 158
1
2
BS06K387
Connect the fuel line (4) to rail (2) following the
procedure shown in the following figure (step 157).
IMPORTANT: Fuel line (4) connections shall be
tighten to 20 Nm (14.8 lb.-ft.) of torque, using the
proper box wrench
380000158 (3).
STEP 159
A
1
BS06K388
Press the clamp (1) in arrow direction (Figure B) and
connect the line to the rail (2), figure 2-260), reset the
clamp to the initial locking position (Figure A).
IMPORTANT: Check for proper fuel line connection.
2-118
ENGINE REPAIR MANUAL
CHAPTER 2 - 667TA ENGINE OVERHAUL
Figure 2-261
and the torque wrench
B
1
Figure 2-262
STEP 160
3
1
4
2 3
BS06K389
Check wiring cable (5) condition, replace it if
damaged, by cutting the support (2) clamps and
removing the bolts (4) that secure it to connectors
(3). Install a new gasket (1) on the support (2).
STEP 161
1
2
BS06K390
Install the wiring support (2) and tighten the bolts (1)
to the general bolt torque specifications in the repair
manual.
4
Issued 11-06 Bur
5
Figure 2-263
Figure 2-264
87519804 NA