New Holland 667TA/EEG Repair Manual page 135

STEP 155
1
2
BS06K384
Apply Loctite 5999 to the contact surfaces of intake
manifold (1) and install the manifold and heater to the
cylinder head.
Screw in bolts (2) and tighten to 20 to 30 Nm (14.8 to
22.1 lb.- ft.) the specified torque.
Install air intake (4) with a new gasket (5) and tighten
bolts (3) to the general bolt torque specifications in
the repair manual.
The figure shows the air intake for 667TA/EEG -
667TA/EEC engines.
87519804 NA
ENGINE REPAIR MANUAL
CHAPTER 2 - 667TA ENGINE OVERHAUL
3
4
5
Figure 2-258
Issued 11-06 Bur
STEP 156
1
2
3
4
5
BS06K385
Install the rail (2) and tighten the bolts (1) to the
general bolt torque specifications in the repair
manual. Connect the ground cable (3) to the intake
manifold (4) and tighten the fastening nut (5) to 20 to
30 Nm (14.8 to 22.1 lb.- ft.) the specified torque.
STEP 157
1
2
3
BS06K386
Connect new fuel lines (1) to rail (3) and injector
manifolds (2).
IMPORTANT: When ever fuel lines (1) are removed
they should always be replaced with new ones
Figure 2-259
Figure 2-260
2-117