New Holland 667TA/EEG Repair Manual page 137

STEP 162
1
2
3
BS06K391
Connect the electrical cables (1) to the injectors (3)
and use Special Tool 380000158 torque wrench (4)
to tighten the fastening nuts (2) to the general bolt
torque specifications in the repair manual.
STEP 163
1
2
BS06K392
Install a new gasket (2) on the tappet cover (1).
STEP 164
1 2
BS06K393
Install the tappet cover (1) and tighten the nuts (2) to
20 to 30 Nm (14.8 to 22.1 lb.-ft.) the specified torque.
87519804 NA
ENGINE REPAIR MANUAL
CHAPTER 2 - 667TA ENGINE OVERHAUL
4
Figure 2-265
Figure 2-266
Figure 2-267
Issued 11-06 Bur
STEP 165
1 7
2
BS06K394
Re-attach exhaust manifold (6) with new gaskets.
Screw securing bolts (5) and tighten them to
48 to 58 Nm (35.4 to 42.8 lb.-ft.) the specified torque.
Re-attach turbo-charger (1) to exhaust collector (6)
with a new gasket and tighten securing nuts (7) to
20 to 30 Nm (14.8 to 22.1 lb.-ft.) the specified torque.
Connect line (2) to turbo-charger (1) support (3).
Connect oil line (4) to heat exchanger support.
STEP 166
1 2
BS06K395
Connect the air duct (2) to the turbo-charger (3) and
lock it with clamp (1).
6
5
4
3
Figure 2-268
3
Figure 2-269
2-119