Table of Contents
Advertisement
After Replacing Laser Optics Housing Unit
Important: First, open the front cover and turn on the machine.
Then, input the setting values for the laser optics housing unit
with "LSU Adjustment".
"SP Mode 2" tab
Close the front cover
Execute "Color Registration"
"SP Mode 2" tab
Adjust the registration settings for each tray and for the front
and rear side of the paper if necessary.
"Registration" in the "SP Mode 2" tab
LSU Adjustment:
See RTB for procedures when EEPROM must be reset even
though the laser optics housing unit has not been changed. (New
machines are not shipped with sheet of paper containing values,
and there is no known procedure to print values on a list.
Slide 81
.
81
MD-P1b / M040 / C311N
MD-P1c / M041 / C312DN
Advertisement
Table of Contents
