Toshiba RAV-GM1601AT8P-E Service Manual page 96

No. Part name
Heat 1. How to remove the frame of heat
"
exchanger
exchanger
1) Recover the refrigerant gas.
2) Proceed 1 of 1, 2, 3, 4.
3) Take off TO-sensor.
4)
discharge pipe connected to the
ASM-COND.
5)
assembly of heat exchanger and the
partition board. and SUB
PARTITION.(ST1T Ø4 × 10, 5 pcs.)
Take off screws between the
6)
assembly of heat exchanger and the
bottom plate.(ST1T Ø4 × 10, 2 pcs.
7) Pull the back side of the assembly
of heat exchanger.
2. How to attach the assembly of heat
exchanger (maintenance part)
1) Proceed through the reverse order of
NOTES:
※Don't remove the cap from the joint of the
assembly of heat exchanger (maintenance
part) till you braze. And don't neglect the
assembly of heat exchanger (maintenance
part) without cap for a long time.
Procedure
Using a burner remove the
Take off screws between the
how to remove
※The pipe fixing plate and pipe cover
that come with the assembly of heat
exchanger, before replacement, are just
for shipping. There is no need to attach
them.
However, make sure to fasten a screw
that attach the pipe fixing plate (ST1T
Ø4 × 10, 1 pcs.) to the assembly of
heat exchanger, after replacement.
Screw
SCREW
- 96 -
Remarks
TO sensor
Take off piping from
ASM-COND
Screw