Toshiba RAV-GM1601AT8P-E Service Manual page 89

No. Part name
Inverter box 1. How to remove
4
1) Proceed 1 of 1.
Never disassemble the inverter for 3
minutes after power has been turned off
because an electric shock may be caused.
2) Take off the inverter cover.
3) Take off the connector that connecting
4)
5)
6) Take off lead of REACTOR from
7) Take off terminal cover of compressor,
8) Lift the ASM-BOX-INV up.
Procedure
WARNING
Take off screws between the inverter
cover and the inverter box.
(CTT2T Ø4 × 10, 1 pcs.)
with control board.
(TD, TS, TE, TL, TO-Sensor,
COIL PMV, ASM-THERMO-COMP,
ASM-HP-SW, ASM-COIL-4WAY,
FAN-MOTOR (UPPER and LOWER)
*Take off the connectors by pulling the
connector body. Do not pull the wire.
*Connectors should be removed after
unlocking the housing section.
Take off lead of FAN-MOTOR
(LOWER) from EDGE-SADDLE and
WIRE-SADDLE.
Cut the CABLE-TIE that cover lead of
FAN-MOTOR (UPPER), Take off lead
of TD, TS, TE, TL, TO-Sensor,
COIL PMV, ASM-THERMO-COMP,
ASM-COIL-4WAY and ASM-HP-SW
from EDGE-SADDLE, WIRE-SADDLE
and CABLE-CLAMP.
REACTOR.
take off lead of compressor from
compressor and CORD-CLAMP.
FAN-MOTOR (UPPER)
WIRE-SADDLE
- 89 -
Remarks
Inverter cover
Screw
TD, TS, TE, TL,
TO-Sensor, COIL PMV,
ASM-THERMO-COMP,
ASM-HP-SW ,
ASM-COIL-4WAY
FAN-MOTOR (LOWER)
EDGE-SADDLE
Lead of FAN-MOTOR (UPPER)
CABLE-TIE
EDGE-SADDLE
CABLE-CLAMP
Lead of REACTOR
Lead of compressor