Toshiba RAV-GM1601AT8P-E Service Manual page 93

No. Part name
1. Removal of broken compressor
Compressor
8
1) Take off the refrigerant gas.
2) Carry out works of 1 of 1 and 2, 3, 4.
3) Take off the piping panel (Front).
4) Take off the piping panel (Rear).
5) Take off the valve fixing plate. Take off
6) Take off TD sensor fixed to the
7) Take off the sound insulating plate.
8) Take off terminal cover from the
9) Using a burner, remove the discharge
In case of take off the piping by broiling
the welded part with a burner, if the piping
includes oil, it may burst into flames at
the moment when wax melted, so take
sufficient care.
Note so that the flame does not catch the
PMV and High pressure switch.
(An operation may become an error.)
10) Pull off the discharge pipe and the
11) Take off the compressor bolts which fix
12) Pull out the compressor toward you.
Procedure
Take off screws of the piping panel
(Front) and the bottom plate.
(ST1T Ø4 × 10, 2 pcs.)
Take off screws of the piping panel
(Front) and the piping panel (Rear).
(ST1T Ø4 × 10, 1 pc.)
Take off screws of the piping panel
(Rear) and the bottom plate.
(ST1T Ø4 × 10, 2 pcs.)
bolts of the valve.
(Hexagonal screw Ø6 × 15, 4 pcs.)
Take off screws of the valve fixing plate
and the partition plate.
(ST1T Ø4 × 10, 1 pc.)
Take off screws of the valve fixing plate
and the reinforcing plate.
(ST1T Ø4 × 10, 1 pc.)
discharge pipe.
(Upper side, Inside, outer winding)
compressor and then remove the
compressor lead and also the
ASM-THERMO-COMP.
pipe and the suction pipe connected to
the compressor.
WARNING
CAUTION
suction pipe of the refrigerating cycle
upward.
the compressor to the bottom plate.
(3 pcs.)
Piping
panel
(Front)
TD sensor
Compressor bolt (4 pcs.)
- 93 -
Remarks
Piping
panel
(Rear)
Take off
(Discharge pipe)
Take off
(Suction pipe)