Table of Contents
Advertisement
then remove the clip remove
it as shown in the illustration.
2
Disconnect the claws and
remove the service cover.
3
Remove the reservoir cap.
4
Add brake fluid slowly while
checking the fluid level.
Make sure to check the fluid
type and prepare the necessary
6-3. Do-it-yourself maintenance
item.
FMVSS No.116 DOT 3 or
SAE J1703 brake fluid
Fluid
type
FMVSS No.116 DOT 4 or
SAE J1704
Item
Clean funnel
■
Brake fluid can absorb moisture
from the air
Excess moisture in the brake fluid
can cause a dangerous loss of brak-
ing efficiency. Use only newly
opened brake fluid.
WARNING
■
When filling the reservoir
Take care as brake fluid can harm
your hands and eyes and damage
painted surfaces.
If fluid gets on your hands or in
your eyes, flush the affected area
with clean water immediately.
If you still experience discomfort,
see a doctor.
NOTICE
■
If the fluid level is low or high
It is normal for the brake fluid level
to go down slightly as the brake
pads wear out or when the fluid
level in the accumulator is high.
If the reservoir needs frequent
refilling, there may be a serious
problem.
Adding the washer fluid
If any washer does not work or
"Windshield Washer Fluid Low"
is shown on the multi-informa-
tion display, the washer tank
may be empty. Add washer
393
6
Advertisement
Table of Contents
