Table of Contents
Advertisement
■
Jam protection function
Sensors are equipped on both sides
of the power back door. If anything
obstructs the power back door while
it is closing, the back door will auto-
matically operate in the opposite
direction or stop.
■
Fall-down protection function
While the power back door is open-
ing automatically, applying exces-
sive force to it will stop the opening
operation to prevent the power back
door from suddenly shutting.
■
Back door closing assist
If the back door is lowered manually
when the back door is stopped at an
open position, the back door will
fully close automatically.
■
Back door reserve lock function
This function is a function which
reserves locking of all doors, before-
hand, when the power back door is
open.
When the following procedure is
performed, all the doors except the
power back door are locked and
then power back door will also be
locked at the same time it is closed.
1
Close all doors, except the back
door.
2
During the power back door clos-
ing operation, lock the doors
using the smart key system from
the side doors (P.131) or the
wireless remote control.
(P.131)
Operation signals will indicate that
all the doors have been closed and
locked. (P.132)
●
If the electronic key is placed
3-2. Opening, closing and locking the doors
inside the vehicle after starting a
close operation via the door
reserve lock function, the elec-
tronic key may become locked
inside the vehicle.
●
If the power back door does not
fully close due to the operation of
the jam protection function, etc.,
while the back door is automati-
cally closing after a door reserve
lock operation is performed, the
door reserve lock function is can-
celed and all the doors will unlock.
●
Before leaving the vehicle, make
sure that all the doors are closed
and locked.
■
Close & lock function operat-
ing conditions
This function can be operated when
all of the following conditions are
met:
●
An electronic key is not detected
within the vehicle.
●
All of the doors other than the
power back door are closed.
●
The power switch is in OFF.
■
Situations in which the close &
lock function may not operate
properly
In the following situations, the close
& lock function may not operate
properly:
●
If the
switch on the lower
part of the power back door is
pressed by a hand which is hold-
ing an electronic key
●
If the
switch on the lower
part of the power back door is
pressed when the electronic key is
in a bag, etc. that is placed on the
ground
●
If the
switch on the lower
part of the power back door is
pressed with the electronic key
141
3
Advertisement
Table of Contents
