Table of Contents
Advertisement
6
Repeat the steps above to
program another device for
any of the remaining
®
HomeLink
buttons.
Programming a rolling code
■
system
Two or more people may be
needed to complete rolling code
programming.
1
Locate the "Learn" or "Smart"
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by
manufacturer. Refer to the owner's
manual supplied with the garage
door opener motor for details.
2
Press and release the
"Learn" or "Smart" button.
3
Perform
within 30 seconds after
performing 2.
5-4. Using the other interior features
3
Press and hold the desired
HomeLink
vehicle) for 2 seconds and
release it. Repeat this
sequence
(press/hold/release) up to 3
times to complete program-
ming.
If the garage door opener
motor operates when the
HomeLink
pressed, the garage door
opener motor recognizes the
HomeLink
Enabling 2-way communi-
■
cation with a garage door
(only available for compati-
ble devices)
When enabled, 2-way communi-
cation allows you to check the
status of the opening and clos-
ing of a garage door through
indicators in your vehicle.
2-way communication is only
available if the garage door
opener motor used is a compati-
ble device. (To check device
compatibility, refer to
www.homelink.com.)
®
button (inside the
®
button is
®
signal.
365
5
Advertisement
Table of Contents
