Table of Contents
Advertisement
5-1. Using the air conditioning system and defogger
air conditioning mode switch.
■
Notes on touch switch opera-
tion
●
Operate using a finger (the pad of
the finger).
●
If a coating, film, etc. is applied to
the surface of the air conditioning
control panel, non-response may
occur.
●
If a pen, etc. is used to operate
the system, the system will not
respond.
●
When performing a touch opera-
tion, make sure that other fingers,
etc. do not touch the air condition-
ing control panel.
●
When performing a series of touch
operations, withdraw the finger
completely before performing the
next operation.
●
Do not forcefully press the air con-
ditioning control panel.
●
If the air conditioning control panel
is dirty or has liquid attached to it,
incorrect operation may occur.
Wipe the control panel clean
before performing any touch oper-
ations.
■
Situations when non-response
may occur from normal touch
switch operation
●
Gloves, etc. are worn.
●
A coating, film, etc. is applied to
the surface of the air conditioning
control panel.
●
The air conditioning control panel
is dirty or has liquid attached to it.
●
The vehicle is in an area where
strong electrical waves or noise
are emitted, such as near a televi-
sion tower, power plant, gasoline
station, broadcasting station, large
display, airport, etc.
●
Wireless devices such as radios,
cell phones, etc. are carried.
●
The air conditioning control panel
is in contact with, or covered by, a
metallic object such as the follow-
ing:
• A card that has metal on it, such
as aluminum foil, etc.
• A pack of cigarettes that use alu-
minum foil
• A wallet or bag that is made of
metal
• Coins
• A heating pad
• CDs, DVDs or other media
●
If your hand is near or touching
the air conditioning control panel
when the power switch is turned to
ACC or ON, non-response may
occur. If so, withdraw your hand
from the air conditioning control
panel and wait approximately 10
seconds before touching the air
conditioning control panel again.
■
When non-response from touch
switch operation
When the air conditioning control
panel is dirty, non-response may
occur.
Clean the touch panel frequently.
■
When cleaning the air condi-
tioning control panel
Touch switches may respond when
cleaning. Turn the power switch to
OFF before proceeding with clean-
ing.
■
Ventilation and air conditioning
odors
●
To let fresh air in, set the air condi-
tioning system to the outside air
mode.
●
During use, various odors from
inside and outside the vehicle may
enter into and accumulate in the
air conditioning system. This may
then cause odor to be emitted
from the vents.
●
In order to suppress odors that
occur when the air conditioning
system starts, the air flow mode
may change to blow air to the feet
or air may stop blowing for a short
period of time immediately after
the air conditioning system is
started in automatic mode.
325
5
Advertisement
Table of Contents
