Daikin Altherma R Hybrid Installer's Reference Manual page 103

To connect the PC cable to the switch box
To access the most used commands
CHYHBH05+08AF + EHYKOMB33A
Daikin Altherma R Hybrid
4P471761-1E – 2020.10
Accessing settings – Legend for tables
You can access the installer settings using two different methods. However, NOT all
settings are accessible via both methods. If so, the corresponding table columns in
this chapter are set to N/A (not applicable).
Accessing settings via the breadcrumb in the menu
structure.
Accessing settings via the code in the overview
settings.
See also:
▪ "To access the installer
▪ "8.1.5 Menu structure: Overview installer
Prerequisite: The EKPCCAB4 kit is required.
1 Connect the USB connector of the cable to your PC.
2 Connect the plug of the cable to X10A on A1P of the switch box of the indoor
unit.
3 Pay special attention to the position of the plug!
2
3
4
5
To access the installer settings
1 Set the user permission level to Installer.
2 Go to [A]: > Installer settings.
Method
4
settings" [ 103]
settings" [
8 Configuration
|
Column in tables
#
For example: [A.2.1.7]
Code
For example: [C-07]
4
138]
Installer reference guide
103