Installation - Fagor 3IF-ZONE95AC Instruction Manual

INSTALLATION

Installation of hob
● The thickness of furniture surface should be between 28 and 40 mm, the depth of the
surface – at least 600 mm. The surface should be flat and properly levelled. The surface
should be sealed and protected against water spill and moisture from the side of the wall.
The distance between the edge of the hole and the edge of the surface should be at least
50 mm from the front and the back
● Prepare the place (hole) in the furniture surface according to the dimensions shown in the
installation drawing (Fig. A).
● Leave at least a 50 mm gap between the device and the neighbouring vertical walls of
cupboards.
● The height of the installed hob is 50 mm.
● If the hob is separated from the rest of the installation cabinet with a horizontal safety plate,
the space between the bottom of the hob casing and the safety plate should be at least
25 mm – this will enable free air circulation. The minimum space between induction hobs
should be at least 75 mm. (Fig. B.)
● The veneer and the glues affixing it to the furniture intended for hob installation should be
resistant to the temperatures of 100°C. Failing to meet this requirement may cause surface
deformations or detaching of the veneer.
● The edges of the hole should be protected with a material resistant to moisture absorption.
● In the back section of the protection plate a notch should be made with a width of at least
80 mm.
● The cable profile should be selected in accordance with hob power (this should be done
by an authorised technician).
● Connect the hob to power supply using the electric cable according to the attached con-
nection diagram.
● Remove dust from the surface, insert the hob in the hole and press it down into the surface
(Fig. C).
Fig. A
43