Fagor 3IF-ZONE95AC Instruction Manual page 57

OPERATION
Clock function
The programming clock facilitates cooking as it can control how long heating zones are active.
It can also be used as a timer.
Switching the clock on
The programming clock facilitates cooking
as it can control how long heating zones are
active. The function can only be activated
when cooking (when heating power is higher
than „0"). The clock function can be switched
on simultaneously for all five heating zones.
The clock can be set in the range of 1 - 99
minutes with 1 minute steps.
To set the time on the clock, you should:
● using sensor (+) (2) or (-) (3) select heating
power in the range 1-9. The selected he-
ating power will light up on the display in
the range of 1-9 with a decimal point (e.g.
(4)).
● then you simultaneously press sensor (+)
(5) and sensor (-) (6) of the clock. On the
clock display (7) figures (00) will appear
and the central LED (8), located under the
display (7), will start to blink.
● then keep simultaneously pressing sensor
(+) (5) and sensor (-) (6) of the clock until
LED is selected (8) that matches the he-
ating zone that is to be clock-controlled.
● having selected the required LED (8) lo-
cated by the display (7), set the operating
time of the heating zone using sensor (+)
(5) or sensor (-) (6).
4
10
2
3
7
8
6 5
8
7
8
5
6
11
1
57