Fagor 3IF-ZONE95AC Instruction Manual page 59

OPERATION
Using clock as the timer
The clock programming cooking time can be used as the timer only if the operation of heating
zones is not time-controlled.
Switching on the timer
To set the timer, you should:
● simultaneously press sensor (+) (5) and
sensor (-)(6) of the clock. On the clock
display (7), figures (00) will appear and the
central LED (8), located under the display
(7), will start blinking.
● then with sensors (+) (5) or (-) (6) of the
clock set the timer operation time.
Switching the timer off
When the programmed cooking time lapses, a continuous sound signal will be produced that
can be switched off by touching any sensor or it will switch off automatically after 2 minutes.
If it is necessary to switch off the timer earlier, reduce the time to (00) using sensor (-) (6).
7
8
5
6
59