Fagor 3IF-ZONE95AC Instruction Manual page 58

OPERATION
Changing the programmed cooking time
At any point in the process of cooking you may change its pre-programmed duration.
To do that repeat the same programming procedure as under the point „Switching on the
clock" but do not set heating power using sensor (+)(2) or sensor (-)(3), but go directly to the
procedure of clock activation by simultaneously pressing sensor (+)(5) and (-)(6) of the clock.
Cooking time control
The time remaining until the end of cooking may be checked any time by touching sensor (+)
(5) and (-) (6) until the required LED (8) is selected. The currently displayed time is signalled
by the blinking LED (8).
Switching the clock off
When the programmed cooking time lapses,
a sound signal will be produced that can be
switched off by touching any sensor or it will
switch off automatically after 2 minutes.
If you need to turn off the clock earlier:
● Simultaneously press sensor (+) (5) and
sensor (-) (6) until the required LED (8) is
selected that indicates operation of the
heating zone using the timer, and then
using sensor (-) (6) reduce the time down
to (00).
58
8
7
8
5
6