Fagor 3IF-ZONE95AC Instruction Manual page 52

OPERATION
Control panel
● Once you connected the hob to the power network, all indicators will light up at the same
time. The hob is ready for work.
● The hob is equipped with electronic sensors which you switch on by pressing them with
the finger for at least 1 second.
● Each of the sensor settings is signalled with a sound signal.
Do not put any objects on the sensors (this may trigger the defect identification signal).
Their surfaces should be clean at all times.
Switching the hob on
If the hob is switched off, all heating zones are
turned off and the indicators are off.
The hob is switched on by touching the main
sensor (1)¬. On all indicators of heating zones
(4) „0" appears for 10 seconds. Now you can
adjust heating power using sensor (+)(2) and
sensor (-)(3) for a given heating zone.
(see Heating power level adjustment).
If within 10 seconds no sensor has
been activated, the hob switches off.
If the lock is activated, the LED by
the key sensor (10) lights up and
you cannot switch on the hob (see
Unlocking the hob).
Switching a heating zone on
Once you switched on the hob, using the
switch on/off (1) sensor select the heating
power level for a given heating zone using
sensor (+) (2) or (-) (3. ¬If you start heating
power adjustments with sensor (+) (2),
heating power (4) will first appear on the
display. If, however, you start heating po-
wer adjustment with sensor (-)(3), heating
power (9) will appear on the display.
52
4
2
3
4
4
10
3
2
2
3
1
11
1