Fagor 3IF-ZONE95AC Instruction Manual page 46

INSTALLATION
Connecting the plate to the electrical system
Note!
The plate can be connected to the mains only by a qualified certified installer. Wilful
adaptations or modifications to the electric system are prohibited.
Guidelines for the installer
The plate is provided with a terminal box enabling selection of proper connections for the
given type of power supply.
The terminal box enables the following types of connection:
- one-phase 230 V -
- two-phase 400 V -
- three-phase 400 V -
The plate can be connected to the appropriate power supply by adequate bridging on the
connection strip, in accordance with the attached wiring diagram. The wiring diagram is also
provided in the bottom part of the lower cover. The connection strip can be accessed once the
cover on the terminal box is removed. Please remember to match the mains connection cable
to the type of connection and the rated power of the plate.
Note!
Do not forget to connect the protective circuit to a clamp of the connection strip marked
with sign. The plate power supply system should be protected by appropriately se-
lected safety device or after the power supply protection, by appropriate safety switch
cutting off the power in case of emergency.
Before connecting the plate to the electric system read information provided on the rating
plate and wiring diagram.
Note! The installer is obliged to complete and leave with the user a "certificate of connecting
the plate to the mains" (attached to the warranty card).
Methods of connection other than those indicated on the diagram can damage the plate.
46