16 SERVICE WORK ON THE ENGINE
16.3
106
401955-11
Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
V00834-10
401955-11
Guideline
Oil drain plug with
magnet
–
2
Remove filler plug
with the O-ring, and fill up with gear oil.
Gear oil
–
Mount and tighten filler plug
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check for leaks.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
1
Remove screw
with the seal ring.
–
2
Remove filler plug
with the O-ring.
–
Add gear oil up to the bottom edge of the hole of the gear oil
level plug.
Engine oil (15W/50) (
–
Mount and tighten screw
Guideline
Screw, gear oil level
monitoring
–
Mount and tighten filler plug
M12
20 Nm (14.8 lbf ft)
0.50 l
Engine oil
(0.53 qt.)
(15W/50)
(
p. 122)
2
with the O-ring.
p. 105)
p. 122)
1
with the seal ring.
M6
8 Nm (5.9 lbf ft)
2
with the O-ring.