KTM 85 SX 2021 Owner's Manual page 42

10 TUNING THE CHASSIS
40
Main work
–
Remove protection cap
–
Push together fork airpump
Fork airpump (79412966100)
Info
The fork airpump is included as part of the motorcycle's
accessory pack.
S03413-10
–
Connect the fork airpump to the left fork leg.
The fork airpump switches on automatically.
A little air escapes from the fork leg when connecting.
Info
This is due to the volume of the hose and not due to a
defect in the fork airpump or the fork.
Read the accompanying KTM PowerParts instructions.
–
Adjust the air pressure as specified.
Guideline
Air pressure
Gradual changing of the air
pressure in steps of
Minimum air pressure
Maximum air pressure
Info
Never adjust the air pressure to a value outside the
stated range.
–
Disconnect the fork airpump from the left fork leg.
When disconnecting, excess pressure will escape from the
hose – the fork leg does not lose any air.
The fork pump airpump switches off automatically after
80 seconds.
–
Mount the protection cap.
Info
Only mount the protection cap by hand.
Finishing work
–
Remove the motorcycle from the lift stand. (
1
.
2
fully.
5 bar (73 psi)
0.2 bar (3 psi)
4 bar (58 psi)
8 bar (116 psi)
p. 44)