17 Cleaning, Care; Cleaning The Motorcycle - KTM 85 SX 2021 Owner's Manual

17 CLEANING, CARE

17.1
Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
–
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
–
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
108

Cleaning the motorcycle

Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
60 cm (23.6 in)
–
Close off exhaust system to keep water from entering.
–
Remove loose dirt first with a soft jet of water.
–
Spray the heavily soiled parts with a normal commercial motor-
cycle cleaner and clean using a brush.
Motorcycle cleaner ( p. 124)
Info
Use warm water containing normal motorcycle cleaner
and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always
rinse the vehicle with water first.
–
After rinsing the motorcycle with a gentle spray of water, allow
it to dry thoroughly.
–
Remove the closure of the exhaust system.
–
Empty the carburetor float chamber.
Warning
Danger of accidents Moisture and dirt impair the
brake system.
–
Explain to your child that he or she must brake
carefully several times to dry out and remove dirt
from the brake linings and the brake discs.
–
After cleaning, let your child ride the vehicle a short distance
until the engine warms up and the brakes have dried due to
careful application of the brakes.
( p. 102)