Setting Jumpers; Jumper Settings - ECS P6IEMT Manual

Jumper Settings

Jumper Type Description
JP1 3-pin Clear CMOS
JP2 2-pin BIOS flash
protection
Jumper 1 – This jumper enables you to clear the BIOS. Refer
to the following instructions:
1. Turn the system off.
2. Short pins 2 and 3 on JP1.
3. Return the jumper to the normal setting.
4. Turn the system on. The BIOS is returned to the de-
fault settings.
Jumper 2 – This jumper enables you to prevent the BIOS
from being updated (flashed). Set the jumper to unlock to up-
date your BIOS. After updating the BIOS, change it to the
locked setting. For instructions on updating, the BIOS refer to
Chapter 3.
A p p
A p p

Setting Jumpers

Setting (default)
1-2: Normal
1
2-3: Clear CMOS
Open: Unlock
Short: Lock
e n d i x A
e n d i x A
JP1
JP2