ECS P6IEMT Manual page 43

Press <Enter> to display the IDE submenu:
CMOS Setup Utility – Copyright © 1984 – 2001 Award Software
IDE HDD Auto-Detection
IDE Primary Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
↑ ↓ → ← : Move Enter : Select
F5:Previous Values
IDE HDD Auto-Detection
Press <Enter> while this item is highlighted to prompt the
Setup Utility to automatically detect and configure an IDE de-
vice on the IDE channel.
Note: If you are setting up a new hard disk drive that sup-
ports LBA mode, more than one line will appear in
the parameter box. Choose the line that lis ts LBA
for an LBA drive.
IDE Primary/Secondary Master/Slave (Auto)
Leave this item at Auto to enable the system to automatically de-
tect and configure IDE devices on the channel. If it fails to find a
device, change the value to Manual and then manually configure
the drive by entering the characteristics of the drive in the items
described below.
Refer to your drive's documentation or look on the drive casing if
you need to obtain this information. If no device is installed,
change the value to None.
Note: Before attempting to configure a hard disk drive,
ensure that you have the configuration information
supplied by the manufacturer of your hard drive. In-
correct settings can result in your system not
recognizing the installed hard disk.
IDE Primary Master
Press Enter
[Auto]
Menu Level
[Auto]
To auto-detect the
0 MB
HDD's size, head . . . on
0
this channel
0
0
0
0
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults F7:Optimized Defaults
37
Item Help
F1:General Help